The tried and tested Descendit is a classic ski/board shell jacket. It's completely waterproof, windproof and breathable thanks to the seam-sealed DryVent™ fabric technology. The overall look is pared back, but underneath this clean exterior, there are functions like a wrist pass pocket with goggle wipe, underarm vents, an adjustable helmet-compatible hood and a secure chest pocket. Lightweight Heatseeker™ insulation makes this a dependable option for the piste.
DRYVENT™ 2L Waterproof Shell
Waterproof, breathable, seam-sealed DryVent™ 2L shell with a non-PFC DWR finish keeps rain and snow out
Heatseeker™ Synthetic Insulation
Heatseeker™ synthetic insulation made with hollow-core fibres for added warmth, performance, and durability
Helmet-Compatible Hood
Attached, adjustable, helmet-compatible hood with a riveted cord-lock adjustment system
Underarm Venting
Pit-zip underarm vents let you dump heat quickly on the lift line
Wrist Pass Pocket with Goggle Wipe
Secure-zip wrist pocket with a built-in goggle wipe keeps your kit dialed
PU-Coated Zips
Polyurethane-coated, reverse-coil centre front zip and matching chest pocket zip seal out moisture
Secure Hand Pockets
Covered secure-zip hand pockets keep essentials safe
Media-Compatible Internal Pocket
Internal secure-zip chest pocket with a media port plus a large internal mesh drop-in pocket
Adjustable Cuffs
Adjustable cuffs with hook-and-loop tabs seal out snow
Snap-Down Powder Skirt
Snap-down powder skirt with gripper elastic keeps snow out of your baselayers
Internal Hem Cinch-Cord
Internal hem cinch-cord with two-point adjustment; cinch-cord ends exit into the hand pockets for easy reach
Embossed Logo Lining
Embossed logo lining adds a heritage touch inside
General
Type
Insulated Snowsports Shell Jacket
Category
Snowsports Outerwear
Materials
Body
133 g/m² DryVent™ 2L — 100% recycled polyester with non-PFC DWR finish
Lining
72 g/m² 100% recycled polyester plain weave with non-PFC DWR finish
Insulation
Heatseeker™ (70% post-consumer recycled polyester): 60 g body & sleeves, 40 g hood
Construction
Seam-sealed DryVent™ 2L waterproof/breathable shell
Measurements
Center Back Length
Not specified by manufacturer
Cleaning
Close all fasteners before washing. Machine wash cold (30°C) with a liquid technical detergent. Avoid bleach, fabric softener, and dry cleaning.
Drying
Tumble dry on low heat to reactivate the Durable Water-Repellent (DWR) finish on the shell.
DWR Refresh
To restore water repellency over time, tumble dry on low for 10–15 minutes or apply a technical spray-on DWR treatment per the care label.
